TECHNICAL SPECIFICATIONS
- Standards:
IEEE 802.3 10Base-T
IEEE 802.3u
100Base-TX
IEEE 802.3z/ab 1000Base-T
IEEE 802.3x full-duplex flow
control,
1000Base-SX/LX - Connectors / Slot:
P1
— RJ-45/SFP Slot *
P2 — SFP Slot with 1000Base-SX Multi-Mode
Duplex-LC Module
[ * Note: Dual-Media Port-1 can only use
either RJ-45 or SFP slot, but not both at the same time. ]
- Data
Transfer Rate:
10/100/1000Mbps (auto-negotiation or forced mode)
for TP
1000Mbps for fiber - Cable / Max Distance:
50/125µm Multi-Mode fiber, up to 500m (400MHz-Km) or 550m (500MHz-Km)
62.5/125µm Multi-Mode fiber, up to 220m (160MHz-Km) or 275m
(200MHz-Km)
9/125µm Single-Mode fiber, up to 10~50km (SFP Module
dependent)
Category 5e or better UTP, up to 100m for 1000Base-T
Category 5 or better UTP, up to 100m for 100Base-TX
Category 3 or better
UTP, up to 100m for 10Base-T - Duplex-Mode:
Full-Duplex
for 1000Base-SX/LX/T
Full-/Half-Duplex (auto-sense) for 10/100Base-TX
- LEDs:
Unit — PWR (Power)
P1 — SFP
LNK/ACT (Link/Activity)
P1 — TP LNK/ACT (Link/Activity)
P1
— TP SPD (Speed for 10/100/1000Mbps)
[ Green for 1000Mbps, Amber for
100Mbps, OFF for 10Mbps ]
P2 — SFP LNK/ACT (Link/Activity)
- Power Requirement: 0.9A up @ +5VDC
- Power
Consumption: 3.6W
- Ambient
Temperature: 0° to 40° C
- Humidity: 5% to 90%
- Dimensions: 140.7 x 87.7 x 29.4mm (H x W x D)
- Emission and Safety Regulations:
FCC Part 15 Class A
& CE Mark Approval ADDITIONAL
FEATURES
- Link Fault Pass-Through
(LFP)
With LFP enabled (selectable by DIP-Switch at rear panel),
if any segment cable(s) is/are broken, both ports in each converter will be
turned OFF, i.e. no Link LED. If all segment cables are connected good,
both ports in each converter will be turned ON, i.e. Link LED.
|
![[ Search ]](ImgMN/Search.gif)
![[ Products ]](ImgMN/Browse.gif)
![[ Browse by Connector ]](ImgMN/Browse-by-connector.gif)
