Comes with a
3 foot cable that goes inside, through the back and into a USB port on the back
of the computer. Converts the one port on the back of the computer to five
ports on the front.
| Fits in a 3-1/2" drive bay, or with the
use of the included adapter, in a 5-1/4" bay. |  |
Key
Features- Fully compliant with USB Specifications 1.0 & 1.1
- Plug
and play compatible
- 5 downstream port with over-current detection and
protection per port
- Portable and Daisy Chainable
- Two power source modes
(Self-Power and Bus-Power)
- has the same small power connector as a 3-1/2"
floppy drive
- Up to 12Mbps bandwidth to USB device
- Each port supports
1.5Mbps and 12Mbps (for low speed/full speed devices)
- Supports all USB
devices: Keyboard, Mouse, Monitor, Modem, Scanner, Printer, etc.
USB
Notes:- USB peripherals can connect either to a computer's port or to
a hub.
- If the computer doesn't have enough ports for all the peripherals, a
hub is necessary.
- Maximum length on individual cables is 5 Meters.
- No
terminators are needed on this bus.
- The A (flat) type port would be
considered the "out" port on a computer or hub.
- The B (square) type port
would be considered an "in" port on hubs or peripherals.
- A typical USB "out"
(Type-A) port can provide up to 500mA.
- The speed is 12 Megabytes per second
for USB 1.1 or 480 Megabytes per second for USB 2.0, the maximum number of
peripherals to a controller is 63 (hubs needed when the computer runs out of
ports).
|
![[ Search ]](ImgMN/Search.gif)
![[ Products ]](ImgMN/Browse.gif)
![[ Browse by Connector ]](ImgMN/Browse-by-connector.gif)
